Tips and How to Remove the Starter From Machines Dinamo

Tips and how to remove the starter car or disassembly of the machine if you want to replace the starter armature or How to disassemble and install a car starter dynamo and here's how to remove the starter motor or starter dynamo removing the car from the engine and dynamo how to install the starter back to the car engine .The steps of assembling the starter motor to take the car for example is Toyota 1NZ - FE engine.The equipment needed to open and install the starter dynamo1.Kunci 10 fitting , ring or combination2.Kunci 12 ring or combination3.Kunci 14 shock , shock connection handlebar short and RachetHow to Dismantle Car StarterOnce the equipment is prepared , while see the image above , the next step is :

1.     Open Kleman head minus or negative battery to prevent short circuit when removing the starter terminal Kleman . 
   
2.  Open the nut 12 to open the terminal Kleman 30 starters in the picture above figures arrows designated No. 1
3.  Open the starter solenoid or a loose connector or terminal 50 , number 2 arrows no . 
4.   Use Key Rachet with 14mm shock and short connections to open two starter bolts that bind the starter with the engine . There is also a car that uses three bolts to tie the starter to the engine .

How to Install a Car Starter dynamoWhile step how to install a car starter is the opposite of the steps to disassemble

1.     Put the starter back into place with the position of the starter solenoid is located on top 
2.   If the position is correct , install two starter bolts that make the starter attached to the machine , tighten the bolts just enough to lock the shock 14mm and rachet . 
3.  Attach the solenoid connector or cable wiring terminal 50
4. Attach the terminal wires 30 and its fasteners with lock nuts 12 or ring combinations .
5. After the second starter cables installed properly , the bolts tight enough holder , attach the negative battery terminal or minus off earlier . 
6.  Turn on the machine to check the starter work rewinding machine

Hopefully useful information on how to disassemble the plug or how to install a car starter above .